- Startseite
- Forum
- Auto
- Volkswagen
- Lupo
- servolenkung justierung
servolenkung justierung
ist hier jemand der vieleich einen Manual hat wie man einem electronischem servo steuerung Calibriert?? ich habe vag.com und den kan ich auch einstellen aber ich die neuen daten nicht speichern!?
Ähnliche Themen
23 Antworten
Ok, I looked at the documents again, and what I allready wrote is still right.
Control module 03, Group 060
Before starting the basic setting, you have to login with 40168.
*edit*
Which fault codes are stored in the Brake control module?
Zitat:
Original geschrieben von Theresias
Ok, I looked at the documents again, and what I allready wrote is still right.
Control module 03, Group 060
Before starting the basic setting, you have to login with 40168.
*edit*
Which fault codes are stored in the Brake control module?
i have tryed too login whith 40168 in control module
03, but the group 060 says: FAIL
there are no fault codes in the brake control module.
Fail in measuring mode (08) or fail in basic setting mode (04)?
04
Well, I looked it up once again, it's definitly 03 and group 060 with the login 40168.
The Problem must be somewhere else.
ok. but why can i calibrate it in 44? do you know that?
is it the guide too lupo 3l from 2002 you have?
This procedure (above) is for the ITT 20 IE ABS-System, there is another procedure, that might be helpful in combination with #44.
First of all the following values have to be checked:
#44 -> Function 08 -> Group 001
Field 1 = Lenkposition should be ~0
Field 2 = Lenkmoment
The basic setting:
Function 04 -> Group 001
Wait 20 seconds.
If this basic setting is done and ok, go directly to group 015 in basic setting mode.
Wait 20 seconds.
If this is ok too, switch of the ignition for more than 5 seconds.
After that start the engine and turn the steering wheel more than 270° in every direction.
Thats is. Hope this helps.
THANKS!!!!
i will try that tomorrow, it looks very fine!!
i will return whit the results!
du you have a guide for # 44 -> function 10 ?